If you have met the same issues like above, that mean your screen If your Autel MS906, MS906BT, MS906TS, MS908P or Maxisys Elite have the same issues : Problem and how I responded quickly to get the results that they In this article, we see what happens when the clients receive the Take a long time depending on the module (PCM is the longest). Vehicle, connect it and it automatically programs the module. Information for that module, disconnect again and run back to the Tis2000, connect it to the computer and download the programming Then you disconnect, run to the computer running The Tech 2 to the vehicle and download the module information that you The vehicle and uses the gm Tech2 scanner as a go-between. ***the reprogramming of an ECU that was not exchanged or the replacement/programming of a new ECUĢ.The go-between method is for when you can’t bring the computer into * On the screen ‘Select Diagnostic Tool and Programming Process’ (See picture below) make a selection for * Select the icon ‘Service Programming System’ (Fig.
#Volvo premium tech tool v2.04.55 Pc#
* Connect Tech 2 to the PC switch on Tech 2.
#Volvo premium tech tool v2.04.55 software#
Method is faster, and it is recommended when a pc with TIS2000 software That is, the data are directly downloaded from the PC to the ECU in the vehicle.Īlthough the GM Tech 2 is still necessary in the mode, the data entryĪnd the download control is done directly at the pc. Uses the Tech 2 as the connection between. One is pass-through and the other is using the Tech 2 as a go-between.ġ.The pass-through is to use with a laptop in the vehicle and it just For program a module with Tech 2 Scan Tool, there are two methods.
0 kommentar(er)
